home *** CD-ROM | disk | FTP | other *** search
- Orchid ProDesigner II
- Windows 3.0 Driver
- Addendum (Readme file)
-
-
- ┌──────────────────────────┤IMPORTANT├────────────────────────────────┐
- │ │
- │ The instructions which follow are applicable to users of Microsoft │
- │ Windows 3.0 and the ProDesigner II. Please note that the 512 KB │
- │ ProDesigner II will support the 1024x768 (with 16 colors) and the │
- │ 800x600 (with 16 colors) drivers on this disk. The 1024 KB │
- │ ProDesigner II supports all of the drivers on this disk. Attempting │
- │ to install and run the 1024 KB drivers on a 512 KB ProDesigner II │
- │ will cause the Windows 3.0 display to wrap around the screen or not │
- │ display at all. Please use the appropriate drivers for your │
- │ ProDesigner II memory configuration. │
- │ │
- │ Please be sure your monitor supports the drivers you wish to run. │
- └─────────────────────────────────────────────────────────────────────┘
-
-
-
- This addendum supersedes the instructions found on pages 20 and 21 of
- the ProDesigner II manual. Please disregard the Windows 3.0
- installation information found there.
-
- The ProDesigner II Drivers on this disk contain drivers for several
- popular modes, including support for 1024 x 768 with 256 colors. Also
- included is a replacement Windows 3.0 SETUP.INF file that will permit
- you to change your display options from within Windows 3.0.
-
- Carefully follow the instructions listed below to install the drivers:
-
- ───────────────────────────────────────────────────────────────────────
- Quick Install (These instructions assume you are an experienced user)
-
- 1. Install Windows 3.0 in the usual way, selecting the standard IBM
- VGA as your video display adapter.
-
- 2. Copy the contents of the ProDesigner II Windows 3.0 Driver Disk to
- your Windows System directory.
-
- 3. When you are running Windows 3.0 you may change your display type
- by using the Windows Setup program residing in the Main desktop
- window.
-
- ───────────────────────────────────────────────────────────────────────
- Standard Installation:
-
- 1. Use DISKCOPY to make a copy of the Windows 3.0 Setup disk (Disk 1).
-
- 2. Return the original Windows Setup Disk to its disk sleeve.
-
- 3. Using the copy of the Windows Setup Disk, copy the file SETUP.INF
- from the ProDesigner II Windows Drivers disk to the newly-created copy
- of the Windows Setup Disk.
-
- 4. Still using the copy of the Windows Setup Disk, run the Windows 3.0
- Setup program to begin installation of Windows 3.0.
-
- 5. When the configuration list is shown, review it for any changes you
- wish to make. If you wish to change the display type, you may select
- an appropriate ProDesigner II driver from the Display Driver list.
-
- 6. Windows will prompt you to insert the ProDesigner II Windows 3.0
- Driver Disk into your floppy drive to install the requested driver.
- Once the appropriate files have been copied, the Windows Setup
- installation program will continue normally.
-
- 7. After you complete the above steps you can begin using Windows 3.0.
- Once Windows 3.0 is installed you may change your display type by
- using the Windows Setup program residing in the Main desktop
- window.
-
- ───────────────────────────────────────────────────────────────────────
-